Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: 8600 Fan noise
SIINC, I originated that post for a loud fan issue and open ticket with Flex. Fan noise from my 8600 was not sustainable. I was told by Flex to open radio and check if there any cables touching the F…1 -
Re: GNSS Antennas
I have GPSDO from ebay (image below) for the last 5 years or so. Antenna mounted at the window that looking south. While signal is weak - it is reliably locked all the time. I tried GNSS on both wind…1 -
8600 Fan noise
Received yesterday 8600 and installed it today. Still going through some AG/TGXL/PGXL troubleshooting and setup but would like to bring up the FAN noise issue. It will be impossible for me to use 860…1 -
Re: MicroHam and Flex6000
Did anyone tried to connect Microham DXP for CW and SSB messages operation? I know I can use logs for that but if it possible I would use an external device like DXP. Thanks, Sergey1 -
Re: Bit cable output 3.3VDC to 12VDC step up converter
Completed and tested, all good, thanks1
